Inhaltsverzeichnis
Werbung
TRANSMISSION, SHIFT CAM AND SHIFT FORK
c
2. Install:
NOTE:
• Apply the molybdenum disulfide oil on the
inner and end surface of the idler gear and
on the inner surface of the sliding gear, then
install.
• Apply the lithium soap base grease on the O-
ring.
3. Install:
NOTE:
• Be sure the circlip sharp-edged corner a is
positioned opposite side to the plain washer
and gear b.
• Install the circlip with its ends c settled
evenly on the spline crests.
c
4. Install:
NOTE:
• Apply the lithium soap base grease on the oil
seal lip.
• When installing the spacer into the crank-
case, pay careful attention to the crankcase
oil seal lip.
4 - 104
• 2nd wheel gear (26T) 1
• 4th wheel gear (21T) 2
• 3rd wheel gear (21T) 3
• 5th wheel gear (21T) 4
• 1st wheel gear (29T) 5
• O-ring 6
To drive axle 7.
• Plain washer 1
• Circlip 2
New
• Collar 1
ENG
Werbung
Inhaltsverzeichnis
