Troubleshooting Guide - Scheppach MGT410 Originalbetriebsanleitung

Troubleshooting guide

Fault
The equipment does not
work
Equipment operates
intermittently
Saw chain is dry
Chain/guide bar is hot
Chainsaw judders, vibrates
or does not saw properly
Possible cause
Battery empty
Battery is not correctly inserted
Loose connection (external)
Loose connection (internal)
ON/OFF switch defective
No oil in the tank
Vent in the oil tank cap is blocked Clean the oil tank cap
Oil outlet is blocked
No oil in the tank
Vent in the oil tank cap is blocked Clean the oil tank cap
Oil outlet is blocked
Chain is blunt
Chain is overtensioned
Chain is undertensioned
Chain is blunt
Chain is worn
Saw teeth point in the wrong
direction
Remedy
Charge battery
Remove battery and insert again
Consult a specialist workshop.
Top up with oil
Clear the oil outlet
Top up with oil
Clear the oil outlet
Re-sharpen or replace the chain
Check the chain tension
Adjust the chain tension
Re-sharpen or replace the chain
Replace the chain
Refi t the chain with the teeth facing in the correct direction
27 І 44