Scheppach MGT410 Originalbetriebsanleitung Seite 26

the equipment with a clean cloth or blow it with com-
pressed air at low pressure.
• We recommend that you clean the device immediately
each time you have fi nished using it.
• Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents or
solvents; these could attack the plastic parts of the
equipment. Ensure that no water can seep into the
device. The ingress of water into an electric tool incre-
ases the risk of an electric shock.
Maintenance
Chainsaw mounting kit
Replacing the saw chain and cutter rail
The cutter rail needs to be replaced if the guide groove
of the cutter rail is worn; Proceed as described in the
section "Assembly of the cutter rail and the saw chain".
Checking the automatic chain lubrication
You should check the operation of the automatic chain
lubrication system on a regular basis in order to guard
against overheating and the associated damage to
the cutter rail and the saw chain. To do this, point the
tip of the cutter rail towards a smooth surface (board,
section of a cut tree) and allow the chainsaw to run. If an
increasing oil trace becomes evident during this process
then the automatic chain lubrication system is working
properly. If no clear oil trace is evident then please refer
to the corresponding instructions in "Troubleshooting". If
the information contained there still fails to remedy the
situation then please contact our service department or
another similarly qualifi ed workshop.
Important! Do not actually touch the surface with the tip
of the cutter rail when performing this test. Keep a safe
distance (approx. 20 cm).
Sharpening the saw chain
Effective working with the chainsaw is only possible if
the saw chain is in good condition and sharp. This also
reduces the risk of kickback. The saw chain can be
re-sharpened by any dealer. Do not attempt to sharpen
the saw chain yourself unless you have the necessary
special tools and experience.
Storage
Perform the cleaning and maintenance before storage.
Store the equipment and accessories in a dark and dry
place at above freezing temperature. The ideal storage
temperature is between 5 and 30 °C. Store the electric
tool in its original packaging.
26 І 44
D