Troubleshooting - Scheppach RS400 Original Bedienungsanleitung

Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
disposed of at a designated collection point. This can
occur, for example, by handing it in at an authorised
collecting point for the recycling of waste electrical
and electronic equipment. Improper handling of waste
equipment may have negative consequences for the
environment and human health due to potentially
hazardous substances that are often contained in
electrical and electronic equipment. By properly dis-
posing of this product, you are also contributing to the
effective use of natural resources. You can obtain in-
formation on collection points for waste equipment
from your municipal administration, public waste dis-
posal authority, an authorised body for the disposal of
waste electrical and electronic equipment or your
waste disposal company.

16. Troubleshooting

The following table shows fault symptoms and describes remedial measures in the event of your machine failing to work
properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Motor does not run
Motor running but screen
drum does not turn
Screening material is not fully
screened
22 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Possible causes
Connection cable defective
Switch defective
Motor belt defective or tension too
low
Screen drum belt defective or ten-
sion too low
Screening material clumping and/or
too moist
Screen drum angle too steep
Action
Check connection cable and replace if neces-
sary
Arrange for inspection and repair of the device
by a specialist
Check motor belt, tension or replace
Check screen drum belt, tension or replace
Crush the screening material first and/or wait un-
til the screening material is drier.
Reduce the angle of the screen drum