Troubleshooting - Scheppach MFH380-20Li Dual Original Anleitungen

tentially hazardous substances that are often con-
tained in electrical and electronic equipment. By
properly disposing of this product, you
are also contributing to the effective use of natu-
ral resources. You can obtain information on collec-
tion points for waste equipment from your municipal
administration, public waste disposal authority, an
authorised body for the disposal of waste electri-
cal and electronic equipment or your waste disposal
company.
13.

Troubleshooting

The table below contains a list of fault symptoms and explains what you can do to remedy the problem if your equip-
ment fails to work properly. If the problem still persists after working through the list, please contact your nearest ser-
vice workshop.
Fault Possible cause
Machine does not start •
•
•
•
•
Machine works with • Power cable damaged
interruptions
• Internal connections are loose
• On/Off switch faulty
Poor cutting quality • Blades are blunt.
Motor is running but • The power unit is jammed by a thick
the gears are not branch or other objects.
engaging
Pole saw does not • Chain tension too high.
saw, it plucks or • Chain blunt.
vibrates. • Chain attached incorrectly.
• Chain worn.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Battery empty
Battery is not correctly inserted
On/Off switch faulty
Worn carbon brushes
Motor faulty
Batteries and rechargeable batteries do not be-
long in the household waste!
As the consumer you are required by law to
bring all batteries and rechargeable batteries,
regardless whether they contain harmful sub-
stances* or not, to a collection point run by the local
authority or to a retailer, so that they can be disposed
of in an environmentally friendly manner.
*labelled with: Cd = cadmium, Hg = mercury, Pb =
lead
• Remove the batteries from the laser before dispos-
ing of the machine and the batteries.
Remedy
• Charge battery
• Remove battery and insert again
• Contact the service centre
• Contact the service centre
• Contact the service centre
• Check the extension lead and have it replaced,
if required.
• Contact the service centre
• Contact the service centre
• Have the blades sharpened or the knife bar
replaced.
• Turn the hedge trimmer off immediately,
disconnect the electricity supply and remove
the blockage.
• Check and reset chain tension.
• Have the chain sharpened or replace it.
• Re-attach the chain.
• Replace the chain.
GB | 41