Troubleshooting; Possible Cause - Scheppach RS350 Original Bedienungsanleitung

15. Troubleshooting

The following table shows fault symptoms and describes remedial measures in the event of your machine failing to work
properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Motor does not run
Motor running but screen
drum does not turn
Screening material is not fully
screened
22 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58

Possible cause

Connection cable defective
Switch defective
Motor belt defective or tension too
low
Screen drum belt defective or
tension too low
Screening material clumping and/or
too moist
Screen drum angle too steep
Remedy
Check the connection cable and replace it, if
required.
Arrange for inspection and repair of the device
by a specialist
Check the motor belt, tighten or replace it.
Check the sieve drum belt, tighten or replace it.
Break up the sievings and/or wait for them to
be drier.
Reduce the angle of the screen drum