leco TECO 680 Betriebsanleitung Seite 89

- Keep the arm in contact with the rim until the machine has acquired the wheel's diameter
and distance values. The following screen appears during this phase.
- If only one measurement is taken, the machine interprets the presence of a rim with
balancing using a clip weight (Dynamic balancing Programme).
- When the automatic internal measurement arm returns to the rest position, the following
icons are automatically displayed on the screen:
: pressing the ENTER button enables alternatively the type of tyre, that is P
-
TYRE (Passenger Tyre) for medium sized wheels (wheels with a tyre shoulder
that does not protrude much from the rim) or LT TYRE
large sized wheels (such as off-road, trucks or wheels with a tyre shoulder that protrudes
considerably from the rim);
: each time the ENTER button is pressed, the machine automatically changes
-
the type of balancing programme (as shown on the graphic on the video) in the fol-
lowing sequence: DYNAMIC-ALU1-ALU2-ALU3-ALU4-ALU5-STATIC-MOTORCYCLE
DYNAMIC-MOTORCYCLE ALU.
: press the dimensions button to enter width manually;
-
- press the button during the indicated phase to return to the working environment,
maintaining the previous width;
- in this phase, it is possible to perform a new acquisition of the rim planes;
- lowering the guard confi rms the selection that was made (manual width entry or wheel
type selection) and the width scanning and spin are performed.
Operator's manual TECo 680 - 680 PlUS - 680 PlUS Pl
(Light Truck Tyre) for
89
EN