leco TECO 680 Betriebsanleitung Seite 108

If the automatic measuring arm fails to operate, the geometric data can be entered
manually by following the procedure below:
- select the manual wheel data entry icon
- the data screen showing the icons is displayed:
manual wheel data change;
unit-of-measurement (inch/mm) change;
displays the help information regarding the current screen.
- select the dimension change icon
;
- the wheel balancer prepares for manual
entry of the width;
- change the displayed value with the value
measured with the manual calliper using
the keypad;
- press the Enter
and switch to the diameter value entry
phase;
- change the value of the diameter displayed
by entering that indicated on the tyre using the keypad;
- press the Enter
- change the value of the distance displayed by entering that indicated on the internal
sensor (A, Fig. 24) using the keypad;
- press the Exit
Automatic locking device PL opening/closure function
If the control pedal PL is not working (M, Fig.8), the locking system PL can be opened/
closed as follows:
108
manual wheel data entry function
button to confirm
button to confirm and switch to the distance value entry phase;
button to terminate the manual data setting.
Operator's manual TECo 680 - 680 PlUS - 680 PlUS Pl
;
24