leco TECO 680 Betriebsanleitung Seite 115

LED2. In this configuration, the light turns on in the conditions indicated for the LED1
programme and, in addition, also in the following conditions:
- when the internal sensor is extracted. When the sensor returns to the rest position,
the light turns off;
- during the entire measurement cycle with all balancing programmes;
- during the Hidden Weight programme when selecting the two planes behind the
spokes.
LEDOFF: deactivated
Press the ENTER button to select the desired mode. The selected icon is enabled if it
is in the following configuration:
- press to confirm the selection made and exit the function.
It is possible to activate or deactivate the laser when present on the machine.
After the list of the setting programmes is displayed:
- Select the LASER activation/deactivation icon
- Two icons will appear on the display that represent the possible LASER modes, as
shown below:
LASER OFF.
LASER ON. In this configuration, the laser turns on in the following cases:
for the manual application of all adhesive weights.
Press the ENTER button to select the icon desired.
The selected icon is enabled if it is in the following configuration:
- Press to confirm the selection made and exit the function.
ATTENTION:
The list of the configuration programmes can be displayed as follows:
- select the utility and configuration programmes
- select the configuration programmes icon
- Select the icon "view other icons"
Operator's manual TECo 680 - 680 PlUS - 680 PlUS Pl
laSEr activation/deactivation
icon;
EN
115