leco TECO 680 Betriebsanleitung Seite 107

• the counter of the spins performed since the last machine reset
• the counter of the weight quantity saved since the last machine reset;
• a histogram showing a comparison between the spring weight quantity required if the
Minimum Weight programme is not used (red rectangle), and the quantity required if
the Minimum Weight programme is used (green rectangle), in relation to the entire
working life of the machine;
• a histogram showing a comparison between the adhesive weight quantity required
if the Minimum Weight programme is not used (red rectangle), and the quantity
required if the Minimum Weight programme is used (green rectangle), in relation to
the entire working life of the machine.
Note: the values shown by the counters are updated with each spin in relation to
the Minimum Weight programme selected.
The Reset icon allows you to zero-set the partial counters.
This function allows the operator to check the balancing results on the screen with the
best possible accuracy ("Gr x1" or "Oz 1/10").
- Select the highest accuracy
- Keep the Enter
After the list of the utility programmes is displayed:
- select the spin counter icon.
A window where the values of three counters are shown is displayed:
- the first counter value is the overall number of wheel spins performed by the machine
since it was started up for the first time;
- the second counter value is the number of
partial spins performed by the machine (it
is reset each time the machine is turned
off or by selecting the
- the third counter value is the number
of wheel spins performed since the last
sensitivity calibration.
Press the Exit button to no longer display
the counters .
Operator's manual TECo 680 - 680 PlUS - 680 PlUS Pl
Highest accuracy function
icon;
button pressed as long as desired.
Spin counter function
icon);
;
EN
107