leco TECO 680 Betriebsanleitung Seite 71

IMPORTANT: for the correct and safe operation of the machine, the lighting level in the
place of use should be at least 300 lux.
The floor must be strong enough to support a load equal to the weight of the equipment
plus the maximum load allowed. The support base on the floor and the envisaged fixing
means must also be taken into account.
Environmental operating conditions must comply with the following requirements:
- relative humidity ranging from 30% to 80% (without condensation);
- temperature ranging from 5° to +40°C.
WARNING
For information concerning the technical features, warnings and maintenance
instructions consult the related operator manuals provided with the documenta-
tion of the machine.
CAUTION
The machine must not be operated in potentially explosive atmospheres.
The machine is supplied partially disassembled and is to be assembled according to the
procedures described below.
lCD monitor and relevant support assembly instructions
- Mount the monitor support (A, Fig. 4) on the weight tray as shown in figure 4;
- block the support to the support itself using the four included screws (b, Fig. 4);
- Unpack the monitor and fix it to the support flange using the four screws supplied with
the machine (C,Fig. 4).
C
A
B
- Connect the signal cable that exits under the rear panel to the monitor (F, Fig. 4) and the
power supply cable (G, Fig. 4) to the machine's rear panel (F,G, Fig. 4a).
Operator's manual TECo 680 - 680 PlUS - 680 PlUS Pl
F
G
4
B
A
G
F
EN
4a
71