leco TECO 680 Betriebsanleitung Seite 72

Wheel guard and support fi tting procedure
- Install the bush (A, Fig. 5) on the pivot (b, Fig. 5). While doing this, ensure that the groove
on the pivot is aligned with the pin in the bush.
- Fasten the tube on the pivot using the M12 screw supplied.
- insert the metal tube (D, Fig. 5a) into the two plastic guard front holes (C, Fig. 5a).
- Couple the guard to the rear side of the tube by inserting it into the correct position with
snap-in coupling (E, Fig. 5a).
- Secure the wheel guard by tightening the screw provided (F, Fig. 5a).
The machine is to be fi xed to the ground if:
- it does not have the accessory triangular foot;
- if it does have the accessory triangular foot but is going to be used with wheels heavier
than 50Kg. In such a case the triangular foot will have to be removed in order to fi x the
front bracket;
- undo the three M8x60 hex head screws fastening the machine to the pallet;
- remove the plastic washers from between the body and the three L shaped brackets:
These brackets are used to fi x the machine to the ground;
- refi t the brackets as originally mounted on the machine, without tightening the screws;
- move the machine into the selected position on the fl oor, ensuring that the minimum
distances indicated in fi gure 7/7a are maintained between the machine and any
surrounding walls/obstacles;
- trace the position for drilling on the fl oor;
- drill in the traced position and then take the included Fischer M8 and insert them into
the holes that were made;
- anchor the machine to the ground, fastening the L shaped brackets to the Fischers
using the relative screws and washers (Fig. 8);
- tighten the three fastener screws onto the body.
72
5
Fixing machine to ground
Operator's manual TECo 680 - 680 PlUS - 680 PlUS Pl
C
E
F
D
5a