Adjustment - SPORTSTECH Speedbike SX600 Benutzerhandbuch

• To adjust the seat height, slacken the spring knob on the vertical post stem on the main frame
and pull back the knob. Position the vertical seat post for the desired height so that holes are
aligned, then release the knob and retighten it.
• To move the seat forward in the direction of the handlebar or backwards away from it, loosen the
adjusting knob and washer and pull the knob back. Slide horizontal seat post into desired positi-
on. Align holes and then retighten the adjusting knob.
• To adjust the handlebar height, slacken the spring knob and secondary knob and pull both knobs
back. Slide the handlebar post along the housing on the main frame to the desired height and,
with the holes aligned correctly, tighten the spring adjusting knob and then the secondary knob.
The device is now ready to use.
Note: would you like to replace the handlebar tapes
on the angled piece of the handle? Then simply
attach them to the handle, starting at the end of the
handle and wrapping from left to right, so that the
middle tape strip sticks completely to the handle.
Ensure that there are no gaps or too wide overlaps
in the bar tape. When you reach the angled piece,
you can cut off the excess tape. Fasten the end with
insulating tape.

ADJUSTMENT

39
EN