Installation Of The Charging Station And Power Supply Unit; Warning - Caution - Stiga Autoclip 527S Bedienungsanleitung

Warning – Caution
EN
Before carrying out any operations, disconnect the robot
from the mains power.
Position the power supply unit in an area that cannot be
reached by children. For example, at a height above 160
cm (63 ").
1.
Install the power supply unit (A)(B).
2.
Remove the protection (L).
3.
Position the base in the predefi ned area.
4.
Insert the perimeter wire (M) under the base.
5.
Connect the two ends of the wire to the terminals of the base.
6.
Fasten the base (N) to the ground with the pegs (P). If necessary,
secure the base with screw anchors (Q).
7.
Connect the power cord (E) of the charging station (N) to the power
supply unit (A)(B).
8.
Connect the plug of the power supply unit (A) to the electrical outlet.
9.
If the LED of the transmitter fl ashes, the connection is correct.
Otherwise, fi nd the anomaly (see "Troubleshooting Guide").
10.
Replace the protection (L).
User's manual

INSTALLATION OF THE CHARGING STATION AND POWER SUPPLY UNIT

(B)
transmitter
black terminal
red terminal
pegs (P)
charging station (N)
transmitter (B)
power cord (E)
charging station (N)
16
(A)
current power supply unit
H. min. 160 cm
(63.00 ")
(L)
protection
perimeter wire (M)
screw anchors (Q)
current power
supply unit (A)
Perimeter
wire
H. min. 160 cm
(63.00 ")
protection (L)