Secondary Areas - Programming Mode; Safety - Programming Mode; Change Password - Stiga Autoclip 527S Bedienungsanleitung

2000 (21520)
2500 (26900)
EN
3000 (32280)
3500 (37660)
If the area to be mowed includes secondary areas based on the defi nition given in the chapter "Preparation and Marking the Boundaries of the
Work Areas", then it is necessary to program the secondary areas so the robot knows how to reach them and how many times.
SECONDARY AREA : Function for defi ning the automatic mowing of a secondary area.
-
Percentage: allows setting the dimensions of the secondary area to
be mowed in respect to entire lawn surface. Below is a table to use as
a guide for confi guring a secondary area:
•
20% indicates a very small area.
•
30% Indicates an area which is approximately one third of the entire
garden.
•
50% Indicates an area which is approximately half of the entire
garden.
•
80% Indicates a secondary area which is bigger than the primary
area.
•
100%. The robot will follow the perimeter wire to mow the secondary
area each time it exits the charging station.
-
Distance: This allows setting the distance necessary for the robot to reach the internal part of the secondary area following the perimeter
wire. It is recommended to measure half the distance of the secondary area to ensure that the robot starts working inside that area.
-
Direction: Indicates the shortest direction for reaching the secondary area. The direction can be clockwise or counter-clockwise. The robot
exits from the charging station and follows the wire in the indicated direction to reach the secondary area.
SECONDARY AREA 2: Function for defi ning the automatic mowing of secondary area number 2. This setting uses the same confi guration
parameters as those used for secondary area 1.
SECONDARY AREA 3: (only for some versions, see "Technical Specifi cations"). Function for defi ning the automatic mowing of secondary area
number 3. This setting uses the same confi guration parameters as those used for secondary area 1.
CHANGE PASSWORD: function for setting or changing the password.
-
No: the password entered does not need to be changed.
-
Yes: for entering or changing the password which will be used to start the robot and disable the alarm. You will prompted to enter the
following information :
•
Password: Enter the old password (manufacturer's default 0000)
•
New password: Enter the new password.
•
Repeat password: Enter the new password again.
User's manual
09:00 13:00
mod. 2L2DE0
09:00 13:30
mod. 2L2DE0
08:00 23:00
07:30 23:30
SECONDARY AREAS – PROGRAMMING MODE
SAFETY – PROGRAMMING MODE
22
09:00 21:00
09:00 22:30
primary area
secondary area 2
(20%, 30MT, counter-clockwise)
counter-clockwise direction
17:00 20:00
18:00 22:30
secondary area 1
(30%, 60MT, clokwise)
clockwise direction