Battery Charging After Prolonged Inactivity; Operating Tips - Stiga Autoclip 527S Bedienungsanleitung

Restarting
Before restarting the robot after a long period of inactivity, proceed as
follows:
1.
Connect the plug of the power supply unit (A) to the electrical outlet.
2.
Reconnect the main electrical power supply.
3.
Position the robot inside the charging station.
4.
Press the ON key.
5.
Enter the password (if prompted) (See "Password Entry").
6.
After a few seconds, the message "CHARGING" will appear on the
display.
7.
The robot is now ready to be used (see "Programming Mode").
Danger - Attention
Do not recharge the robot in explosive and fl ammable
environments.
1.
Supply electricity to the charging station and make sure the plates are
clean.
2.
Position the robot inside the charging station.
3.
Press the "ON" key (A).
4.
Enter the password (if prompted) (See "Password Entry").
5.
After a few seconds, the message "CHARGING" will appear on the
display.
6.
Press the "Start/Pause" key (B). The batteries start the charging cycle.
7.
At the end of the charging cycle (approx. 6 hours), press the "OFF/
STOP" key (C).
8.
Store the robot in a protected and dry place with an ambient temperature
between 10° and 20° C, diffi cult to reach by children, animals, other
foreign objects, etc.
Below are some useful operating tips to follow when using the robot.
-
Even after being suitably informed on the use of the robot, it is always a good idea to simulate some test manoeuvres on fi rst use to identify
the commands and main functions.
-
Check and secure the fastening screws of the main components.
-
Mow the lawn frequently to avoid excessive growth of the grass.
-
Do not use the robot to mow grass which is 1 cm (0.40 ") higher than the cutting blade. In case of high grass, lift the cutting blade and then
lower it gradually on the following days.
-
If the lawn is equipped with an automatic sprinkler system, program the robot to return to the charging system at least one hour before the
sprinklers are turned on.
-
Check the slope of the ground and make sure the maximum values allowed are not exceeded in order to prevent damage to the robot and
the sprinklers.
-
It is recommended to program the robot so that it does not work more than is necessary, also taking into consideration the different growth
rates of the grass in different seasons, so as not to subject it to unnecessary deterioration and reduction of the battery life.
-
When using the robot, make sure the work area is clear of people (in particular, children, the elderly or disabled people) and pets in order to
prevent safety risks. To minimise the chance of injury, program the robot so that it operates at suitable times of the day.

BATTERY CHARGING AFTER PROLONGED INACTIVITY

OPERATING TIPS

Current power
supplyunit (A)
"START/PAUSE" KEY (B)
E N T E R
27
Charging
station (C)
"ON" KEY (A)
"OFF/STOP" KEY (C)
User's manual
EN