Visualising The Display During The Work Phase; Prolonged Inactivity And Restarting - Stiga Autoclip 527S Bedienungsanleitung

1.
On the display appears the message:
2.
Press either the "+" or "-" key to set the fi rst number.
3.
Press "Enter" to confi rm. The cursor moves to the next position.
EN
4.
Repeat the procedure to set all the numbers of the password.
The robot is now ready for use.
While in operation, the following data appears on the display of the robot:
-
left wheel motor speed
-
blade motor speed
-
right wheel motor speed
-
battery voltage
While the robot is charging, the word "CHARGING" appears on the display.
If the robot is outside the working time, the display shows the day and time of the next
scheduled start.
If the robot has not been used for a long period of time, it is necessary to perform a series of operations to guarantee the correct functioning at
the time of reuse.
1.
Fully charge the battery before winter storage. Recharge the battery at least once every fi ve months.
2.
Have the routine maintenance performed by an authorised dealer. This is essential for keeping the robot in good condition. The assistance
service usually includes the following operations:
•
Total cleaning of the robot, the cutting blade and all the other moving parts.
•
Cleaning of the inside of the robot.
•
Checking of robot functioning.
•
Checking and, if necessary, replacement of any worn parts such as the cutting blade.
•
Checking of the battery capacity.
•
If necessary, the dealer may also load new software.
3.
Accurately clean the robot and charging station (see "Robot Cleaning").
4.
Check any worn or damaged components such as the cutting blade and evaluate their replacement.
5.
Store the robot in a protected and dry place with an ambient temperature between 10° and 20° C, out of reach of foreign elements (children,
animals, other foreign objects, etc.). Store the robot at a temperature below 20°C in order reduce the automatic discharge of the batteries.
6.
Disconnect the power plug from the power supply unit (A).
7.
Cover the charging station (C) to prevent any foreign materials from getting inside (leaves, paper, etc.) and for preserving the contact plates.
User's manual

VISUALISING THE DISPLAY DURING THE WORK PHASE

PROLONGED INACTIVITY AND RESTARTING

26
PASSWORD
0000
R
Sx=00 La=00 Dx=00
BATTERY 0000
R
1