Battery Charging On Fi Rst Use; Adjustments; Adjustment Recommendations; Adjustment Of Cutting Height - Stiga Autoclip 527S Bedienungsanleitung

1.
Place the robot inside the charging station.
2.
Press the ON key.
3.
After a few seconds, the "CHARGING" message will appear on the
display.
4.
Press the "Start/Pause" key. The "PAUSE" function appears on the
display. The batteries start the charging cycle.
5.
At the end of charging, the robot can be programmed for initial start-up
(see "Programming Mode").
Important
On fi rst use, always charge the batteries for at least 4 hours.

ADJUSTMENTS

Important
The user must make any adjustments according to the procedures described in this manual. Do not make any adjustments
which are not expressly indicated in this manual. Any special adjustments, not expressly indicated in this manual, must
only be performed by personnel from the Manufacturer's authorised service centre.
Before setting the cutting height of the blade, make sure the robot is safely off (see "Robot Safety Stop").
Important
Use protective gloves to prevent injuries to your hands.
1.
In models equipped with an antitheft alarm, disable it to prevent
activation. (See "Programming Mode").
2.
Unfasten the lid and lift it (A).
3.
Loosen the screw (C).
4.
Lift or lower the cutting group (D) to defi ne the desired height. This
level can be found on the graduated scale.
5.
Tighten the screw (C) until the adjustment is made.
Important
Do not use the robot to mow grass which is 1 cm (0.40 ")
higher than the cutting blade. Reduce the cutting height
gradually. It is recommended to reduce the height by at
least 1 cm (0.40 ") every 1-2 days until the ideal height is
reached.
6.
Lower and fasten the lid (A).
BATTERY CHARGING ON FIRST USE

ADJUSTMENT RECOMMENDATIONS

ADJUSTMENT OF CUTTING HEIGHT

17
"START/PAUSE" KEY
"ON" KEY
E N T E R
cutting unit (D)
screws (C)
Clips release (A)
User's manual
EN