Stiga Autoclip 527S Bedienungsanleitung Seite 32

Problem
EN
The work area is not completely
mowed
Secondary area not completely
mowed
"No Signal" appears on the display
"Out of border" appears on the
display
"Blackout" appears on the display
"Wheel error" appears on the display
"Sync error" appears on the display
User's manual
Cause
Not enough work hours
Cutting blade clogged with deposits and/or
residuals
Cutting blade worn out
Work area too big compared to the actual capacity
of the robot
The batteries are about to run out
The batteries do not charge completely
Programming error
The perimeter wire is not connected correctly
(broken cable, no electrical connection, etc.)
Too much slope
Perimeter wire laid incorrectly
Perimeter wire marking the boundary of the inside
areas (fl owerbeds, bushes, etc.) laid in a counter-
clockwise direction
Overheated power supply unit
Incorrect wheel transmission
Interruption of the power supply to the transmitter
Overheated power supply unit
Presence of other installations nearby
Perimeter wire oxidised caused by damage to the
protective sheathing
Ground is uneven or contains obstacles that
prevent movement
Failure of one or both motors that operate the
transmission of the wheels
The robot's receiver does not recognise the signal
30
Remedies
Extend the working time (see "Programming Mode")
Stop the robot safely (see "Robot Safety Stop")
Warning – Caution
Use protective gloves to prevent injuries to your hands
Clean the cutting blade
Replace the blade with an original spare part (see "Blade
replacement")
Adjust the work area (see "Technical specifi cations")
Replace the batteries with original spare parts (see "Battery
replacement")
Clean and remove any rust from the contact points of the
batteries (see "Robot Cleaning"). Recharge the batteries for at
least 12 hours
Correctly program the secondary area (see "Programming
Mode")
Check the functioning of the electrical power supply, the
correct connection of the power supply unit and of the charging
station (see "Installation of charging station and power supply
unit")
Delimit the area with too much slope (see "Planning of system
installation")
Check that the wire has been installed correctly (too deep,
next to metallic objects, distance between the wire marking the
two elements less than 70 cm, etc.) (see "Planning of system
installation")
Reposition the perimeter wire correctly (counter-clockwise
direction) (see "Installation of perimeter wire")
Adopt the appropriate measures to reduce the temperature of
the power supply unit (ventilate or modify the installation area,
etc.) (see "Planning of system installation")
Check and, if necessary, correctly fasten the wheels
Restart the robot
Adopt the appropriate measures to reduce the temperature of
the power supply unit (ventilate or modify the installation area,
etc.) (see "Planning of system installation")
Contact an authorised Service Centre
Contact your nearest authorised service centre to check the
impedance (Ohm) of the perimeter wire
Make sure the lawn to be mowed is even and does not contain
holes, stones or other obstacles. Otherwise, fi ll in any holes
and remove any obstacles (see "Preparation and marking the
boundaries of the work areas (primary and secondary areas)")
Have the motor replaced or repaired by your nearest
authorised service centre
Turn the robot off and then turn it back on. If the problem
persists, contact your nearest authorised service centre