Switching On/Off - Parkside PAS 4 D6 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

˜ Switching on/off

Switching on/off

On
Off
˜ Cleaning and maintenance
Before cleaning or carrying out any
maintenance:
Set the rotation direction switch
–
middle position . This prevents unintentional
switching on .
Remove the USB cable
–
Remove the bit
11 ] [
–
Disconnect the charger
–
outlet .
Never allow fluids to get into the product .
The product must always be kept clean, dry
and free from oil or grease .
Remove debris from it after each use and
before storage .
Regular and proper cleaning will help ensure
safe use and prolong the life of the product .
Clean the product with a dry cloth . Use a soft
brush for areas that are hard to reach .
In particular clean the air vents after every use
with a cloth and soft brush .
The vents must always be clear .
Action
Press the switch trigger
and hold it in place .
7 ] [
The LED work light
[ 8 ]
lights up .
Release the switch
trigger .
7 ] [
The LED work light
8 ] [
goes off .
to the
5 ] [
.
12 ] [
.
from the socket‑
[ 14 ]
NOTE
Do not use chemical, alkaline, abrasive or
u
other aggressive detergents or disinfectants
to clean this product as they might be
harmful to its surfaces .
˜ Maintenance
Before and after each use: Check the product
and its accessories (screw bits
magnetic bit holder
If required, exchange the accessories for new
ones (see "Changing bits and magnetic bit
holder") .
Observe the technical requirements of the
accessories (see "Technical data") .
˜ Storage
Set the rotation direction switch
middle position . This prevents unintentional
switching on .
Store the product in a dry indoor location
protected from direct sunlight, preferably in its
original packaging .
˜ Transportation
This product contains a Li‑Ion rechargeable
battery and is therefore subject to hazardous
materials regulation . Users may transport the
product with built‑in rechargeable battery on
roads or by sea without special requirements .
The packaging and marking is subject to
special requirements when it is transported by
third parties (e .g . airline, courier, carrier) . A
hazardous materials expert must be consulted
when transported by third parties .
,
11 ] [
) for wear and damage .
10 ] [
to the
5 ] [
GB/IE 31