Changing Rotary Direction; Safety Lock; Changing Bits And Magnetic Bit Holder; Front Cover - Parkside PAS 4 D5 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Start charging
(Fig . B)
Connect the USB cable 12 to the USB port
(Type A) 15 of the charger 14 .
Connect the other end of the USB cable 12
to the USB Type C socket 6 .
The battery status LED 3 shows the
charging status:
Battery status
LED 3
Red
Green
NOTE: The product cannot be used whilst
charging . It is normal for the handle to
warm up slightly whilst charging .
Stop charging
Disconnect the USB cable 12 from the
product .
Disconnect the charger 14 from the socket‑
outlet .
˜ Changing rotary direction
Push through the rotation direction
switch 5 to set the rotary direction
(Fig . C):
Switch
pushed Direction
from
Right (b) Tighten screws
Left (a) Loosen screws
32 GB/IE
Charging status
Charging
Battery is charged up
Direction
indicator
2
4
˜ Safety lock
Set the rotation direction switch 5 to the
middle position so that it protrudes equally on
both sides . The switch trigger 7 cannot be
pressed in this setting .
˜ Changing bits and magnetic
bit holder
Pull out the bit 11 . Insert another type of bit
into the bit holder 1 or the magnetic bit
holder 10 (Fig . D) .
NOTE: Screw bits are labelled according
to their dimensions and their shape . If you
are unsure, always try the particular screw
bit out to see whether it sits in the screw
head without any free play .
˜ Front cover
The front cover 9 can be removed for
attaching other attachments that are available
from PARKSIDE (Fig . E, F):
A1 Torque attachment
A2 Eccentric attachment
A3 Angle attachment
A4 Cutting attachment
˜ Switching on/off
Switching
Action
on/off
On
Press the switch trigger 7
and hold it in place .
The LED work light 8 lights
up .
Off Release the switch
trigger 7 .
The LED work light 8 goes
off .