Inserting The Bit; Switching On/Off - Parkside PASD 4 B2 Originalbetriebsanleitung

GB
bits, they should either be
scrapped or examined by
an expert and, if necessary,
re-inspected.
• Work on live components
may only be carried out by
a qualified technician using
these insulated bits in com-
bination with the PASD 4 B2
cordless screwdriver!
• Never work on live compo-
nents using bits that are not
approved for this purpose!
This results in the following
dangers:
- Risk of electric shock for the
user;
- Exposure of the built-in bat-
tery to external voltage (fire,
explosion);
- Exposure to external voltage
and potential carry-over
(voltage) at the charging
socket and, if applicable,
further potential carry-over
via the connected USB-C
cable at other sources;
- The insulated bits must not
be used with other manual
drive parts (e.g. handles,
ratchet, etc.).
40

Inserting the bit

1. To insert, place a bit (12) in
the bit holder (2).
2. To remove it, pull the bit (12)
out of the bit holder (2).

Switching on/off

The LED work light (3) lights up
as long as the device is switched
on. After switching off, the LED
work light switches off automati-
cally with a short delay.
Remove the power adapter be-
fore starting work with the de-
vice. Do not use any extension
cables. The power adapter
may only be used indoors.
1. To switch on the device,
press and hold the direction
switch (4).
To screw in screws:
Clockwise direction (5)
To unscrew screws:
Counter-clockwise
direction (6)
2. To switch off, release the
direction button (4).