Original Ancillaries / Accessories; Before First Use; Charging The Rechargeable Battery On The Device (See Fig. D); Changing The Bits / Screwdriver Bit Inserts - Parkside PAS 3.6 A1 Bedienungs- Und Sicherheitshinweise

General safety advice for ... / Before first use / Preparing the tool for use
J
Before you carry out any tasks on the
device, transport or store it, make
sure that the direction of rotation
switch is in the middle position (lock).
To prevent the device from starting up uninten-
tionally.
J
Children or persons who lack the knowledge or
experience to use the device or whose physical,
sensory or intellectual capacities are limited
must never be allowed to use the device without
supervision or instruction by a person responsi-
ble for their safety. Children must never be
allowed to play with the device.

Original ancillaries / accessories

Q
J
Use only the ancillaries and accessories
that are detailed in the operating
instructions. The use of ancillaries and ac-
cessories other than those recommended in the
operating instructions could lead to an increased
risk of personal injury for you.

Before first use

Q
Charging the rechargeable
Q
battery on the device
(see Fig. D)
note: The battery is supplied partially charged.
Charge the battery for at least three hours before
first use. You can charge the Li-Ion battery at any
time without risk of shortening battery life. Interrupt-
ing the charging process does not damage the
battery.
Starting the charging process:
j
Connect the Battery charger
50 Hz mains socket.
j
Connect the Battery charger
socket on the device
The rechargeable battery is charged when the
battery indicator
3
40 GB/MT
to a 230 V ~
10
to the charging
10
.
5
changes from red to green.
Ending the charging process:
j
Disconnect the Battery charger
mains socket.
j
Disconnect the Battery charger
charging socket on the device
Changing the bits /
Q
screwdriver bit inserts
Insertion:
j
Insert the bit directly into the tool holder
removal:
j
Pull out the bit out of the tool holder

Preparing the tool for use

Q
Switching on / off the
Q
cordless screwdriver
Switching on:
j
To start the appliance squeeze on the ON /
OFF switch
and then keep it pressed down.
7
Switching off:
j
To stop the appliance, release the ON / OFF
switch .
7
Changing the
Q
direction of rotation
Clockwise:
j
Slide the direction of rotation switch
left.
j
Press the ON / OFF switch
indicator (clockwise)
now screw in the screws.
Anticlockwise:
j
Slide the direction of rotation switch
right.
j
Press the ON / OFF switch
dicator (anticlockwise)
now screw out the screws.
from the
10
from the
10
.
5
.
9
.
9
to the
1
. The direction
7
illuminates. You can
2
to the
1
. The direction in-
7
illuminates. You can
4