Reely Black Mono X V2 Bedienungsanleitung Seite 45

Drive function
Forward travel is controlled with the throttle trigger switch (Figure 1, no. 3). Pulling the throttle trigger switch from the
middle (neutral) position brings the propeller into rotation, with the rotational speed increasing as the switch is pulled
further. The motor runs at maximum speed when the throttle trigger switch is fully pulled towards the handle.
Pushing the throttle trigger switch back to the middle position brings the propeller back to halt.
If the propeller continues to run even when the throttle trigger switch is in the middle (neutral) position, this
can be corrected using the trim buttons "TH/TRIM" as described in section 10. h).
Steering function to the right
The steering function is controlled with the rotary wheel (Figure. 1, no. 2). If you move the rotary wheel from the mid-
dle position to the right, the rudder must move to the right as seen in the direction of travel. The model boat will then
make a turn to the right.
Steering function to the left
If you move the rotary wheel from the middle position to the left, the rudder must move to the left as seen in the direc-
tion of travel. The model boat will then make a turn to the left.
If the rudder moves in a direction different from the steering movement of the rotary wheel, the reverse
switch for steering function (Figure 2, no. 6) is in the wrong position and must be switched over.
Figure 7
Figure 8
45