Charger - Reely Black Mono X V2 Bedienungsanleitung

b) Charger
• The design of the battery charger conforms to protection class II. The charger must be connected to
a properly grounded mains socket of the public supply grid (for charger operating voltage, see section
"Technical data").
• The mains socket the charger is plugged into via the power cord must be easily accessible.
• The charger is only suitable for charging 2- or 3-cell LiPo rechargeable batteries. Never use the charger
for any other purpose. Never use the charger to charge NiMH rechargeable batteries (or rechargeable
batteries other than 2- or 3-cell LiPo ones) to avoid the risk of fire and explosion!
• Only insert a single LiPo rechargeable battery into the charger (the two outputs must never be used at
the same time).
• The charger has XH sockets for connecting the LiPo rechargeable battery. The rechargeable battery
must also have a corresponding XH connector, otherwise matching adapters are required. Always pay
attention to the correct pin assignment.
• Never short-circuit the charger outputs and never connect the outputs together.
• The charger may only be used in dry, enclosed spaces. It must be protected from moisture and damp-
ness; never touch it with wet hands to avoid the risk of death from an electric shock! The same applies
to the power cord and mains plug.
• Do not pull the mains plug out of the mains socket by the cable. Grasp the plug by the side of the housing
and pull it out of the mains socket.
• If the charger and/or the power cord shows signs of damage, do not touch it to avoid the risk of death
from an electric shock! First switch off the mains voltage for the mains socket the charger is plugged
into (switch off the associated circuit breaker or unscrew the fuse, then switch off the ground fault circuit
interrupter so that the mains socket is completely disconnected from the mains voltage). You can then
unplug the power cord from the mains socket.
Dispose of the damaged charger/power cord in an environmentally friendly manner and do not use it
anymore. Make sure you use a structurally identical charger/power cord instead. A defective power cord
must never be repaired!
• Mains-operated devices should not be used by children. Therefore, be especially careful when children
are around. When using the charger, always make sure that children cannot reach it.
• Avoid the following unfavourable environmental conditions at the place of use, and during transportation:
- Wetness or high humidity
- Cold or heat, direct sunlight
- Dust or flammable gases, fumes or solvents
- Strong vibrations, impacts or blows
- Strong magnetic fields, such as those found close to machinery or speakers
• Never use the charger/power cord immediately after it has been brought from a cold room to a warm one.
Otherwise, this may result in the formation of condensate, which can destroy the charger under certain
circumstances. There is also a risk of death from an electric shock! Allow the product to reach room
temperature before connecting it and putting it into use. This may take several hours.
• Make sure that the charger power cord is not kinked or crushed. The same applies to the cables of the
LiPo rechargeable battery.
• Handle the product with care, because it can be damaged by jolts, impacts or a fall from a low height.
34