Orbea RALLON M-LTD Technisches Handbuch Seite 17

32 | ORBEA
SHOCK AND YOKE ASSEMBLY
29" AND MULLET SHOCK YOKES
and mullet (front 29" wheel and rear 27.5" wheel).
shock yoke for that setup.
In full 29" assemblies, it is possible to select between two
geometry options (LOW and LOWER) by modifying the lower
1 9 29 " S H O C K YO K E R AL LO N 22
ART Nº: XA31
Bearings included
LOW-LOWER GEOMETRY SWAP. 29" SHOCK YOKE
1.
2.
3.
5
1 2
LOW
TECHNICAL MANUAL
wheel) only allows for a single geometry setting, which is
Consult the shock yoke raplacement method in this section.
20 MULLET SHOCK YOKE RALLON 22
Unique geometry setting
ART Nº: XA32
Bearings included
3
180º
5
8 N.m
LOWER
B LUE PAP ER R AL LO N · 2022
29" AND MULLET SWAP.
SHOCK YOKE REPLACEMENT
1.
5
5
1
3.
linkage.
8
3
5.
linkage to the recommended torque setting. Consult
the LINKAGE section of this manual to know about the
assembly compounds to be used.
8
12 N.m
5
ORBEA | 33
2. Remove the shock from the frame.
2
4. Remove the shock yoke and replace it with the preferred
4
6.
the recommended torque setting. Consult the SHOCK
ASSEMBLY section of this manual to know about the
assembly compounds to be used. Install the rear wheel
of the size for the shock yoke that you just installed.
5
8 N.m
10 N.m
6
E N
5