Orbea RALLON M-LTD Technisches Handbuch Seite 15

28 | ORBEA
LINKAGE
LINKAGE EXPLODED VIEW
1 4 SEAL KIT LINKAGE-FRAME RALLON 22
ART Nº: XA26
Seal Enduro SE SE 25x32x4VG
1 6 HARWARE KIT LINKAGE-SHOCK YOKE. RALLON 22
Bearings not included
ART Nº: XA28
16.1 Linkage-shock yoke bolt M15xP1
16.2 Bolt seal
16.3 O-ring 1x19mm
16.4 Linkage-shock yoke spacer
TORQUE SETTINGS AND ASSEMBLY COMPOUNDS
Do not apply grease
on thread
GREASE
8
GREASE
12 N.m
GREASE
Do not apply grease
on thread
5
10 N.m
4 5
4 N.m 10 N.m
TECHNICAL MANUAL
15 HARWARE KIT LINKAGE-SEATSTAY RALLON 22
Bearings not included
QTY. ART Nº: XA27
2 15.1
15.2 Linkage-seatstay bolt spacer
17 BEARING KIT LINKAGE-SHOCK YOKE. RALLON 22
QTY. ART Nº: XA29
2
2
2
2
Do not apply grease
GREASE on thread
GREASE
5
10 N.m
8
12 N.m
GREASE
Always follow the recommended
torque settings.
B LUE PAP ER R AL LO N · 2022
LINKAGE ASSEMBLY
1. Using a bearing press, install the linkage pivot point bea-
rings into the frame.
Apply carbon compatible assembly grease into the bea-
QTY.
ring housings.
2
4
QTY.
2
Do not apply grease
on thread
2. Install the bearing seals into the frame. Apply carbon
GREASE
compatible assembly grease into the bearing housings.
Insert the seals into the frame as straigth as possible
and press them until they seat correctly.
GREASE
GREASE
3. Insert the left linkage and axle assembly into the frame
Apply assembly grease on the linkage axle bearing ra-
ces. Do not apply grease on the right linkage mounting
surface of the axle.
4. From the right side of the frame, install the linkage axle
bushing.
GREASE
1
4
GREASE
5.
bearings if needed). The axle o-ring should be installed
before the linkage.
Install the linkage preload bolt and the linkage pinch
bolt. Thread both bolts, but do not tighten them com-
pletely yet.
2
5
4
GREASE
ORBEA | 29
E N
3
GREASE
GREASE
5