Check Or Replace Components Of The Electrical Box - Rivacold Best W R290 Bedienungsanleitung

7.7.5 Checking or replacing components
1. If the evaporator tray [A] must be replaced,
remove it with the side panels [B].
3. Check or replace the fin coil temperature probe [D]
and the coldroom temperature probe [E].

7.8 Check or replace components of the electrical box

7.8.1 Required skills
Electrical maintenance engineer
7.8.2 When to check or replace
Perform this procedure when problems are found on the electrical box components (see "Installation and
operation troubleshooting" on page 129).
7.8.3 Warning
Check or replace the components following the instructions, frequency and all indications in this manual and
in the attached documentation. If necessary, contact RIVACOLD srl assistance.
Instruction manual v. 00 | 9600-0033
Rev.
BEST W R290
2. Check or replace the thermostatic valve [C].
4. Check or replace the drain heater [F].
© 2020 RIVACOLD srl
|
EN
7. Maintenance
127