Rivacold BEST W R290 Bedienungsanleitung Seite 125

EN
7. Maintenance
7.6.5 Checking or replacing the condensing fan unit
7.6.6 Check the condensate drain tray
7.6.7 Check the compressor noise
1. Turn the packaged unit on.
2. Verify that the compressor does NOT generate vibrations or clicking sounds, that is, sounds generated by
short, close, sharp and frequent blows.
3. If the compressor emits or generates vibrations or clicking sounds, it can be broken and must be replaced
(see "Replace the compressor" on the facing page), or there is mechanical clearance between the parts
that must be fixed.
124
BEST W R290
1. Remove the top panel [A].
2. Check or replace the fan unit of the
evaporating part [B].
3. If you need to replace the unit, replace and
rewire the wiring cable because once removed
from the motor, the IP rating is NO longer
guaranteed.
4. Set the panel back in place.
1. Remove the left side panel [A]
2. Check the condensate drain tray [B].
3. Set the panel back in place.
Instruction manual
Rev.
v. 00 | 9600-0033 © 2020 RIVACOLD srl
|