Checking Or Replacing Evaporating Part Components - Rivacold Best W R290 Bedienungsanleitung

EN
7. Maintenance
5. For packaged unit size 1 x 250, remove the
electrical box cover (see "Check or replace
components of the electrical box" on the facing
page) and remove the screws [E].

7.7 Checking or replacing evaporating part components

7.7.1 Required skills
Mechanical maintenance engineer
7.7.2 When to check or replace
Perform this procedure when problems are found on the evaporating part components (see "Installation and
operation troubleshooting" on page 129).
7.7.3 Warning
Check or replace the components following the instructions, frequency and all indications in this manual and
in the attached documentation. If necessary, contact RIVACOLD srl assistance.
7.7.4 Checking or replacing the fan unit
126
BEST W R290
1. Remove the la grid [A].
2. Check or replace the fan unit of the
evaporating part [B].
3. If you need to replace the unit, replace and
rewire the wiring cable because once removed
from the motor, the IP rating is NO longer
guaranteed.
4. Put the condenser-fan motor and grid back in
place.
Instruction manual
Rev.
v. 00 | 9600-0033 © 2020 RIVACOLD srl
|