Maintenance; Maintenance Warnings - Rivacold Best W R290 Bedienungsanleitung

7. Maintenance

This section includes the following topics:
7.1 Maintenance warnings
7.2 Maintenance and cleaning performed by the operators
7.3 Periodic maintenance
7.4 Corrective maintenance
7.5 Remove the front panel
7.6 Checking or replacing condensing unit components
7.7 Checking or replacing evaporating part components
7.8 Check or replace components of the electrical box

7.1 Maintenance warnings

7.1.1 Required skills
Mechanical maintenance engineer
Electrical maintenance engineer
7.1.2 Safety
DANGER! Explosion/Burn. Presence of flammable gas. During maintenance, adopt all the
precautions required by legislation in force and the warnings for adjustments and maintenance
indicated in this instruction manual.
Low temperatures. During maintenance in the coldroom, take breaks to avoid long exposure to low
temperatures.
Only perform the maintenance described in this instruction manual and observe the indicated
l
maintenance frequency.
Before carrying out any type of operation, it is necessary to check for propane leaks (R290) with a
l
special gas detector.
The machines have a factory-sealed refrigerant circuit. At the end of any type of operation that involves
l
the removal/replacement of the gas, it is necessary to seal the circuit hermetically, restoring the factory
conditions.
Failure to reposition the guards at the end of maintenance can cause serious damage. Always refit the
l
guards at the end of maintenance.
At the end of maintenance, check that there are no tools or components left inside the packaged unit.
l
Do not release the products used during maintenance into the environment. Follow the regulations in
l
force regarding the disposal of dangerous and/or polluting fluids.
7.1.3 Isolation from energy sources
Before performing maintenance, disconnect the power plug.
Instruction manual v. 00 | 9600-0033
Rev.
BEST W R290
© 2020 RIVACOLD srl
|
EN
119
120
121
122
122
123
126
127
119