Put The Compressor Box Back In Place - Rivacold Best W R290 Bedienungsanleitung

7.6.8 Replace the compressor
1. Remove the side panels [A].
2. Remove the front panel [B] (see "Remove the
front panel" on page 122).
3. Lower or if necessary, remove the controller panel
[C].

7.6.9 Put the compressor box back in place

1. Remove the side panels [A].
2. Remove the front panel [B] (see "Remove the
front panel" on page 122).
3. Lower or if necessary, remove the controller panel
[C].
Instruction manual v. 00 | 9600-0033
Rev.
BEST W R290
4. Undo the screws [D] and remove the
5. Insert the new compressor, securing it with the
6. Set all the panels in place again.
4. Remove the compressor box [D], removing all
© 2020 RIVACOLD srl
|
compressor [E], removing all the components
that prevent its removal.
screws and put all the other components back
in place.
the components that prevent its removal.
EN
7. Maintenance
125