Operating The Stove Using The Dialing Knob; Possible Operational States Of Your Stove; Starting Up Your Pellet Stove - Austroflamm Clou Pellet Benutzerhandbuch

English

4 Operating the stove using the dialing knob

Possible operational states of your stove

Stove is switched off
ECO mode standby /
flame on the right and the power zone at
the bottom flash green

Starting up your pellet stove

To start your stove using the dialing knob:
Turn the dialing knob clockwise from the starting position as
far as it will go. (= 9 o'clock position)
Your stove starts: The flame in the top right-hand corner
begins to flash green, the display panel then lights up com-
pletely white. This means that your stove is now in the auto-
matic start phase. This is a fully automatic process. The
pellets are ignited and the firebox is brought to operating
temperature. The automatic start takes approximately 10
minutes.
The stove indicates the completion of the start phase by means of a permanently lit green flame. Your
pellet stove is now ready for your desired power setting.
You can also start your pellet stove with the optional WLAN-BOX (smartphone and Austroflamm
PelletControl app). To do this, however, you must first position the dialing knob at least in the 3 o'clock
position.
!
NOTE: We recommend that you heat the stove for at least 1 hour at setting 5 after the start-up
phase. The lining in the firebox - the Keramott - needs around 400 °C in the firebox to burn off soot
and deposits. At this temperature, the Keramott remains white.
10
Start phase / flame on the right flashes
green
Alarm indicator / flame on the right flashes
yellow
Cooling down & standby / flame on the
right glows blue
Error indicator / flame on the right glows
red