Clearing Alarm & Error Messages - Austroflamm Clou Pellet Benutzerhandbuch

English
Error code
Error- E113
Error- E114
Error- E115
Clearing alarm & error messages
Error message
If an error occurs, the stove stops and the flame at the top right glows
red. In addition, one or more power zones light up in different colours
depending on the error. You can quickly identify the cause of the error
by looking at the luminous image. Displayed errors can be deleted with
the dialing knob after the source of the error has been eliminated. To
do this, move the dialing knob clockwise from the "OFF" position to
any power level and immediately back to the "OFF" position.
Alarm message
In the event of an alarm message, the flame at the top right lights up / flashes yellow. The alarm message
must be investigated and the cause must be rectified. To cancel the fuel level alarm, there is a RESET button
(see picture). The reset button can be accessed underneath the tank cap.
16
Description
The temperature in the
flue gas ducts is too
high
The temperature in the
firebox is too low.
SYSTEM ERROR
Solution
The flame temperature sensor measures excessively
high flue gas temperatures. The stove switches off
for safety reasons. Contact your Austroflamm ser-
vice engineer for a solution.
Possible causes for this message are:
1. The pellet hopper is empty. Check the level in the
fuel tank. Refill the tank.
2. The automatic start process has failed. Empty the
burn pot. Clear the ERROR and restart the appliance.
If steps 1 and 2 do not help, contact your Austroflamm
service engineer.
The control unit has failed. Contact your Austro-
flamm service engineer for a solution.