Specifying Modulation / Eco Mode - Austroflamm Clou Pellet Benutzerhandbuch

8
English

3.1.6 Specifying modulation / ECO mode

You can operate your pellet stove either in modulation mode or in ECO mode.
In "modulation mode" (ECO mode is deactivated), your stove gradually reduces the heat output to the
lowest level when the room setpoint temperature has been reached. However, it does not switch off de-
spite reaching the desired room temperature. If the setpoint room temperature is not reached at this re-
duced heat output, the stove will start to work again with the heat output that was originally set.
Your stove is delivered in modulation mode as standard.
The ECO mode can be activated by your authorised Austroflamm service engineer or by yourself via the
optional WLAN-BOX and the Austroflamm PelletControl app.
When the ECO mode is activated, the stove switches off once the desired room setpoint temperature
(plus a freely selectable temperature value / stop temperature value) has been reached. If the tempera-
ture falls below the room setpoint temperature (plus a freely selectable temperature value / restart tem-
perature value), the stove switches on again automatically.
The "restart temp." value indicates the value below the setpoint
temperature at which the stove switches on again.
The "stop temp." value indicates the value above the setpoint tem-
perature at which the stove switches off.
To prevent excessive starting/stopping, the temperature limits must not be set too tightly. The stove must
burn for approx. 1 hour before switching off to reach operating temperature.
We recommend a restart temperature of 1.0 °C and a switch-off temperature of 0.6 °C as standard set-
tings.
Your authorised Austroflamm service engineer will discuss with you the settings you require during the
initial commissioning stage.