Cleaning And Maintenance - Austroflamm Clou Pellet Benutzerhandbuch

English

7 Cleaning and maintenance

IMPORTANT: The combustion pot of your pellet stove must be emptied each time before starting the appliance.
Only a cleaned burn pot guarantees safe ignition when starting-up, and clean combustion. With the lifting tool
supplied (see illustrations below), the combustion pot can be easily and safely removed, and taken away for
emptying.
Since the cleaning intervals depend greatly on the place of installation and the operating hours of the stove, the
times given in the following table are only guidelines. Basically, the components listed below must be cleaned in
line with their degree of soiling.
Maintenance work at the end of the service-free operating hours must be carried out by an authorised service
engineer. Maintenance is essential after the service due date (service counter) has expired.
Cleaning the viewing window
Removing any deposits adhering to the burn pot
Cleaning the combustion chamber
Cleaning the flue gas passes
Cleaning the augur shaft, pellet tank
Replacing the stand-by battery CR2032 located in the con-
trol unit
Checking all seals (door, heat exchanger cover, ash box,
tank cap, etc.); replacing them if necessary.
Cleaning the chimney in accordance with the chimney
sweep
19
as required, but after 15 operating
hours at the latest
before each start up
weekly, as required
when the display indicates that a
service is due
once a year or when the pellet in-
feed is visibly reduced
every 2 years
once a year
as specified by local regulations