Fill Level Indicator; Safety Temperature Limiter - Austroflamm Clou Pellet Benutzerhandbuch

English
Reset button
The reset button is accessible at the front right after
opening the tank cap. The fuel level alarm can be
acknowledged using the reset button. The reset
button must be pressed 3 - 4 times in quick succes-
sion.
This button is also needed to fill the auger shaft
during initial operation and after the auger shaft has
been cleaned. For this function, press the button
continuously while the auger is operating.

Fill level indicator

The fill level indication is calculated by the control unit software on the basis of the pellet hopper size and the
burning time. It will only function correctly if the hopper is always filled to capacity when refilling and the fill level
counter is reset at the same time.
To set the fill level counter to "FULL", press the "reset button" several times in quick succession.
This function can be deactivated by your service engineer using the TECHNICAL DISPLAY or in the "Settings/
Fuel" of the Austroflamm PelletControl app.

Safety temperature limiter

Your stove is equipped with a safety temperature limiter on the back. This automati-
cally switches off the stove if the auger shaft overheats. Should this happen, the
cause of the overheating must be determined and remedied. Afterwards, the stove
can be made ready for operation again by pressing the green reset pin in the safety
temperature limiter. The green pin is located under a black cylindrical protective
cap, which must be unscrewed beforehand.
17
Safety temperature limiter with
detachable black protective cap