Setting The Desired Heat Output Or Room Temperature; Heat Output - 5 Levels; Setting The Room Temperature - Austroflamm Clou Pellet Benutzerhandbuch

Setting the desired heat output or room temperature

To switch between the setting for "heat output" and "room temperature", turn the dialing knob an-
ticlockwise to the "OFF" position while the stove is in operation, then immediately turn it clock-
wise again to the desired position.
The display changes colour from "white" – heat output display to "magenta" – room setpoint temperature
display.
CAUTION: Thess functions are only possible while the stove is in operation.
4.3.1 Heat output – 5 levels
Heat output levels 1 - 5
The heat output can be set from 30 % to 100 %
of the nominal heat output in 5 levels.
Simply turn the dialing knob to the desired
power level. The illuminated field shows the set
power level. After setting the power level, your
selection will be confirmed after approx. 5 sec-
onds with a short flash.
Heat output level 1
Heat output level 3
Heat output level 5
Heat output level 2
Heat output level 4
11

4.3.2 Setting the room temperature

Room temperature 5 °C – 40 °C
The room temperature can be set in the range of
+5 °C (frost protection) to +40 °C. After setting
the desired room temperature, your selection will
be confirmed with a short flash after approx. 5
seconds.
It is impossible to display an exact temperature
on the stove. Set the temperature as you see
best.
Range 1: 5°C
Range 3: 20 - 23 °C
Range 5: 30 - 40°C
English
Range 2: 16 - 19 °C
Range 4: 24 - 27 °C