Care And Cleaning - Gastroback Design Dörrautomat Pro Bedienungsanleitung

Problem Reason
The room temperature is
too low.
The humidity of the envi-
ronment is very high.
The internal fuse of the
appliance has been trigge-
red or the heating element
is broken.
Even after switching to This is normal operation.
standby mode, the fan The fan stops operation
runs on. automatically after 10
seconds.
Unusual temperature The temperature unit has
values are shown. been toggled.
EN
46
The Solution
With a high setting of the dehydrating temperature and a
very low room temperature, it is possible that the set tem-
perature is not reached all over the dehydration chamber.
Ensure that the room temperature is between 15°C and
25°C.
The dehydration process depends on the humidity of the
environmental air. When the humidity is very high, you
should expect a prolonged dehydrating time. Increase the
dehydrating time or temperature. However, it is better to
select a room with lower humidity for operation.
Get in contact with an authorized service centre for exami-
nation and repair.
It is good advice to wait until the fan stops working,
before switching the on/off switch to "O" and unplug-
ging the appliance.
Switch back to the unit of temperature, you are used to
(°C or °F; see: 'Operation / Changing the Temperature
Unit').

CARE AND CLEANING

WARNING
– Always unplug the appliance and let it cool down, before
cleaning the appliance. Always ensure that all parts of the appliance are out of
reach of children younger than 8 years and animals. Do not spill or pour any
liquids in or on the appliance or power cord. Do not place or immerse the
appliance or power cord in any liquids. DO NOT place the appliance or power
cord in an automatic dishwasher!
CAUTION
– After a long time of usage, it may occur that dust covers the
interior of the fan assembly. However, DO NOT poke in the fan assembly at the
rear of the dehydration chamber. Instead, you may use a hoover for carefully
sucking off the dust as far as possible. Do not use abrasive cleaning agents or
aggressive liquids (e.g. bleach, solvents) or any hard or sharp-edged objects (e.g.
scoring pads, knives, scrapers) for cleaning the appliance or any part of it. Do not
use violence.
NOTE
During usage, the interior of the dehydration chamber may get coated with a fine
layer of volatile components of the food and drops of juices. To avoid the growth
of harmful germs and an unpleasant odour within the dehydration chamber, you
should clean all used parts of the appliance after each usage.
1. If required, cancel operation via the "Start/Stop" button, wait until the fan stops
working audibly (10 seconds), and switch off via the on/off switch at the rear
(position "O"). Then unplug the appliance. Remove all food trays from the dehy-
dration chamber and remove your food from the food trays. Let the appliance cool
down to room temperature with the door of the appliance left open.
2. Damp a cloth with some warm dishwater, and wipe the complete housing. The-
reafter, wipe with clear water and wipe dry. Leave the housing dry naturally with
the door open. Wash the used inserts (food trays, plastic tablet, plastic tray, sili-
cone muesli pan) in warm dishwater via a soft cloth. Thereafter, thoroughly rinse
with clear tap water. Alternatively, you may clean these parts in an automatic
diswasher.
NOTE
If there are any dried-on residues left on the inserts, soak these parts in warm dish-
water for 5-10 minutes. Then wash the parts (see: step 3).
3. Wipe dry the inserts and leave them dry naturally for approx. 30 minutes.
EN
47