Care And Cleaning - Gastroback 46007 Bedienungsanleitung

Problem
After the sealing process
is fini-
shed the plastic bag is
losing its
vacuum
The container is losing
its vacuum

CARE AND CLEANING

WARNING: Always unplug the appliance and wait some minutes to let the appli-
ance cool down, before moving or cleaning the appliance. Do not touch the sealing
band shortly after operation. Ensure that the appliance is always out of reach of
young children.
Always ensure that no liquids get into the interior of the appliance. Do not place the
appliance or power cord in an automatic dishwasher. Do not immerse the appliance
or power cord in any liquids or spill any liquids on it. Do not pour or drip any liquids
on the appliance or power cord. Always wipe off spilled liquids immediately. Do not
place the appliance on wet or damp surfaces.
Do not use any abrasive cleaners, cleaning pads (e.g. metal scouring pads), or any
corrosive chemicals (e.g. bleach) for cleaning. For easy cleaning clean the appliance
immediately after each use. This way no leftover food will stick, burn-in or carbonise
to the sealing band. Especially ensure not to damage the gaskets and sealing band
when cleaning the appliance.
1. Take out the dripping tray and clean it in warm dishwater.
2. If necessary carefully clean the exterior of the vacuum sealer and power cord.
Take care not to spill or drip water or any other liquids on the appliance.
3. Special care is necessary when cleaning the sealing band and the gaskets with
a soft cloth, moistened with warm dishwater.
4. Wipe the appliance and all parts thoroughly dry and let dry naturally.
5. Replace the dripping tray and close the lid.
The Easy Solution
• Folds, crumbs, grease or humidity on the sealing section of the bag can cause
leaking. Open the bag, clean the interior of the bag in the section where you wish
to seal it and seal the bag again.
• Naturally, some food (e.g. fresh fruits and vegetables) can ferment and gases
can escape.
• Lack of refrigeration or changing temperatures can cause food to deteriorate.
• Check, whether the bag is leaking. You can proof this by dipping the sealed bag
into water. In case of a leak, air would escape when you put slight pressure on the
bag. Seal the bag again or use a new one.
• Check, whether:
- the foam rubber seal of the vacuum chamber is worn out and brittle or damaged.
- the seal at the brim of the container lid is not in place, dirty or damaged.
45