Care And Cleaning; Storage - Gastroback 41620 Bedienungsanleitung

41620_Messer_BDA_k1.qxd 20.07.2010 9:35 Uhr Seite 25

Care and Cleaning

WARNING: Always switch OFF and unplug from power outlet before disassembling parts, or
cleaning the appliance. Do not immerse the appliance or power cord in water or any other
liquids. Do not spill any liquids on the appliance. Do not place the appliance in an
automatic dishwasher.
Do not use any abrasive cleaners, cleaning pads, other hard or sharp-edged objects, chemi-
cals, or corrosive liquids for cleaning as this could affect or damage the surfaces.
Regularly clean the appliance according to the following instructions.
1. Switch OFF and unplug the appliance.
2. Brush the abrasive wheel cover using a dry nylon brush to remove the metal dust. Do not
moisten the brush for cleaning. There will be no advantage in doing so.
3. Wipe the exterior of the aluminium housing carefully with a damp cloth and thereafter wipe
thoroughly dry.
Depending on the frequency of utilization but at least once a month, remove the metal dust that
will accumulate inside the appliance because of the grinding process.
4. To remove the metal particles, turn the Knife Sharpener upside down. At the bottom of the
appliance take out the small black magnet cover as shown in the illustration.
It is best to insert a screw driver into the slot at one side of the magnet cover, and lift the mag-
net cover out carefully. Metal particles will adhere to a magnet attached to the inner side of the
magnet cover.
CAUTION: Do not damage the protruding clips of the magnet cover.
5. Simply brush off the particles from the magnet using a nylon brush.
Note: Some particles will always remain sticking to the mag-
net. This will not have any effect on functioning.
6. If larger amounts of metal particles have been created, you
can shake any remaining dust carefully out of the appliance.
While doing so, turn the appliance a little in all directions.
7. After cleaning, replace the magnet cover securely with the
magnet in place (see figure).

Storage

WARNING: Before storing always unplug and clean the appliance and all its parts and
remove the metal particles that accumulated because of the grinding process. (See: Care and
Cleaning).
Ensure to store the appliance where it is clean, dry and safe from frost, direct sunlight and
inadmissible strain (mechanical or electric shock, heat, moisture) and where it is out of reach
27