Care And Cleaning; Cleaning The Juicing System - Gastroback ADVANCED PRO S Bedienungsanleitung

CARE AND CLEANING

– Always ensure that the appliance and all parts of it are out
WARNING
of reach of children younger than 8 years. To avoid injuries to persons and
damage to the appliance, always unplug the appliance before assembling or
disassembling any parts, and before moving or cleaning the appliance. Do not
touch the drive shaft or the juicing cone with your hands or any objects, and do
not insert any objects (e.g. spoons, spatula) into the filter basket, while the appli-
ance is connected to the power supply.
– Do not place the motor base or power cord in an automatic
WARNING
dishwasher. All parts coming into direct contact with food during operation, may
be cleaned in an automatic dishwasher. To avoid risk of electric shock: Do not place
or immerse the motor base or the power cord in water or other liquids. Do not pour
or spill any liquids onto the motor base or power cord. Do not place the appliance
or power cord on wet surfaces. Always immediately wipe off spilled liquids.
CAUTION – To avoid damage, do not use any abrasive cleaners, corrosive
chemicals (i.e. disinfectants, bleach) or cleaning pads for cleaning the appliance
or any part of it. Do not use any hard or sharp-edged utensils for operation or
cleaning to avoid damage to the surfaces. The filter baskets could easily get bent
or may crack via careless handling, thus making them unusable.
Clean the appliance immediately after each use to avoid that residues of food stick
stubbornly to the surfaces and cause blockage, discolouration, and opaque stains. Do
not poke or scratch with any foreign objects under the drive shaft, or in the juice
outlet of the juice collector, or in the joint of the press arm. Do not use violence.
NOTE
After an elongated time of usage, some surfaces may build up discolouration and
opaque stains caused by fruit acids. This does not influence the performance of
the appliance or the taste of the juices.

CLEANING THE JUICING SYSTEM

1. Unplug the appliance and fold up the juice spout for closing the drip-stop. Remo-
ve your juice vessel.
2. Remove the juicing system from the appliance (see: 'Disassembling the Appliance').
3. Separate the parts of the juicing system and empty the filter basket and juice
collector. If required, remove residues of pulp from the filter basket via a rubber
spatula or wooden or plastic spoon.
EN
59