Accessories - struers Discotom-50 Gebrauchsanweisung

24
Discotom-50
Instruction Manual

2. Accessories

Specification
Adjustable cutting table
For cutting plane parallel sections. It positions the
workpiece at a right angle to the cut-off wheel. Moveable
up to 60 mm.
With 10 mm T-slots and exchangeable steel bands.
Quick clamping device for 10 mm T-slots, Left
For securing the workpiece. Complete with backstop.
Spring clamp
For retaining the cut-off specimen. Complete with
backstop.
Compact quick clamping device for 10 mm T-slots,
Right
For securing the workpiece. Occupies only 45 mm of the
cutting table. To be used together with backstop from
TRESC.
Compact quick clamping device for 10 mm T-slots, Left
For securing the workpiece. Occupies only 45 mm of the
cutting table. To be used together with backstop from
TRELQ.
Vertical clamping system for 10 mm T-slots
For clamping irregular shaped workpieces. Complete with
operating key and one flat clamping shoe
Riser block for 10 mm vertical clamping system
For elevating Vertical Clamping System by 60 mm
Swivel shoes for vertical clamping system
Set of four multi-shaped swivel shoes for TREVS
Recirculation Cooling Unit, 65 l
For water cooling on Discotom-5/-50. With a rolling pallet
Replacement stainless steel bands
Set of 2 pcs. 225 x 40 mm steel bands
Table Unit
With compartment for recirculation cooling unit.
Width: 900 mm, depth: 750 mm, height: 800 mm
Code
TRETA
TRELQ
TRESC
TRERC
TRELC
TREVS
TREKS
TREVI
TRECA
TREUV
LABUL