struers Discotom-50 Gebrauchsanweisung Seite 3

Discotom-50
Instruction Manual
Discotom-50
Safety Precaution Sheet
To be read carefully
before use
1. The operator(s) should be fully instructed in the use of the machine and
its cut-off wheels according to the Instruction Manual and the
instructions for the cut-off wheels.
2. The machine must be placed on a safe and stable support table. All
safety functions and guards of the machine must be in working order.
3. The unit must be installed in compliance with local safety regulations.
4. Use only intact cut-off wheels. The cut-off wheels must be approved for
min. 50 m/s.
5. The machine is not for use with saw-blade type cut-off wheels.
6. Observe the current safety regulations for handling, mixing, filling,
emptying and disposal of the additive for cooling fluid.
7. The workpiece must be securely fixed in the quick-clamping device or
similar. Large or sharp workpieces must be handled in a safe way.
8. Do not work on or around cutting table when the table is repositioned
using the forwards/backwards key (v V).
9. To achieve maximum safety and lifetime of the machine, use only
original Struers consumables.
10. The cutting handle should be lowered slowly and carefully, in order to
avoid breaking the cut-off wheel.
11. Struers recommends the use of an exhaust system as the materials
being cut may emit harmful gasses or dust.
12. The machine emits only moderate noise. However, the cutting process
itself may emit noise, depending on the nature of the workpiece. In
such cases, the use of hearing protection is recommended.
13. The machine must be disconnected from the mains prior to any service.