Accessories - struers Unitom-5 Bedienungsanleitung

Unitom-5
Instruction Manual

2. Accessories

Specification
Automatic Cutting Table
For Unitom-5. Motorized table for cutting plane parallel
sections. Positions the workpiece at a right angle to the cut-
off wheel. With 10 mm T-slots and exchangeable steel
bands. The table is controlled through the Unitom-5.
Table Unit
For Unitom machines. With compartment for Recirculation
Cooling Unit.
Rubber Curtains
To be mounted on Unitom-5 and Unitom-2 for cutting long
protruding workpieces. Set of two.
Flange Set
119 mm diameter For use with cut-off wheels 350 mm
diameter on Unitom machines.
Cutting Table with 10 mm T-slots
Additional table for support of large workpieces. With
exchangeable stainless steel bands. 140 x 315 mm (5.5" x
12.4"). For Exotom and Unitom machines.
Replacement Stainless Steel Bands
For Automatic Cutting Table (UNIEL) and Cutting Table with
10 mm T-slots (UNIFT). Set of three.
Quick-clamping Device for 10 mm T-slots, Left
For securing the workpiece. Complete with back stop. To be
mounted on a cutting table placed at the left hand side of the
cut-off wheel.
Quick-clamping Device for 10 mm T-slots, Right
For securing the workpiece. Complete with back stop. To be
mounted on a cutting table placed at the right hand side of
the cut-off wheel.
Clamping Tools for 10 mm T-slots
For clamping complicated workpieces to the cutting table on
Unitom-5 and Unitom-2. Complete with clamps, supports and
bolts.
Code
UNIEL
LABUL
UNIRU
UNIFL
UNIFT
UNIBA
UNILE
UNIRI
UNIOF
29