Programmable Stop - struers Discotom-50 Gebrauchsanweisung

Programmable Stop

Cancelling the Programmable
Stop
Discotom-50
Instruction Manual
Discotom-50 is supplied with an automatic feature, allowing you
to pre-program a specific stop position.
Position the cutting table at the desired stop position using the
v
FORWARDS and BACKWARDS
Set the stop position by pressing the STOP
it down whilst activating the FORWARDS
Use BACKWARDS
off wheel. Place and clamp the workpiece and press START
The cutting table stops when it reaches the pre-set stop
position and the cutting table moves to the position from where
cutting was started.
Cancel the stop position by pressing the STOP
holding it down whilst activating the BACKWARDS
The stop position will also be cancelled when the machine is switched off.
V
keys.
V
to move the cutting table clear of the cut-
Note
o
key and holding
v
key.
s
.
o
key and
V
key.
15