Light Diode And Beep Signals - struers Discotom-50 Gebrauchsanweisung

Light Diode and Beep Signals

Status
Green POWER indicator on
Green AUTO indicator on
Beep signal
o
Red STOP indicator on
o
Red STOP indicator on
and beep signal
Yellow FEED SPEED
REDUCED indicator on
Yellow FEED SPEED
REDUCED and
o
Red STOP indicator lights
come on
o
Red STOP indicator and
LOAD BAR in red area
o
Red STOP indicator and
LOAD BAR in red area and
beep signal
10
Discotom-50
Instruction Manual
Discotom-50 is provided with various light diodes indicating the
status of the machine. Beep signals will sound if a key is pressed
when the function cannot be activated.
Explanation
The main power switch has been
turned on.
AUTO mode is active.
You pressed AUTO, START
v
FORWARDS or BACKWARDS
while the motor was running.
s
You pressed START
protection guard was open.
s
You pressed START
while cooling valve isn't in cutting
position.
The emergency stop has been
pressed.
The emergency stop has been
pressed and you tried to press
another key.
In AUTO mode: the feed speed is
too high.
An AUTO cut has finished. Feed
speed reduced.
Cutting motor overloaded due to
heavy use:
Material is too hard
Feed speed setting too high
Rotational speed setting too high
Cutting table is jammed
Process halted.
Main motor or frequency inverter
overloaded or overheated.
START was pressed before re-
setting the warning indicator.
Comments
s
,
V
while the
Turn cooling valve to cutting position.
for cutting
Release the emergency stop to shut off
the STOP
The machine automatically turns the feed
speed down.
Reduce feed speed or press any key.
Press any key to stop the indicators.
Solve the problem causing the machine
to stop, for example, by reducing the feed
speed, or using a different cut-off wheel,
then release the emergency stop.
Press the STOP key
warning indicator and wait until the motor
or frequency inverter had cooled down.
o
indicator.
o
to re-set the