struers Discotom-50 Gebrauchsanweisung Seite 37

Clamping the Workpiece
Automatic Cutting
Manual cutting
Discotom-50
Instruction Manual
Quick Reference Card
Secure the workpiece using the clamping device of your choice.
The most common is the quick-clamping device. Place the
workpiece between the clamp and the back stop.
Push the clamp towards the workpiece and lock the quick-
clamping device with the locking handle.
Clamp the workpiece.
Position the cut-off wheel so that it can cut the sample and lock
it in place with the black cut-off wheel locking handle on the
right of the machine.
Position the cutting table with FORWARDS
V
BACKWARDS
Carefully close the protection guard.
Set feed speed and Press AUTO.
s
Press START
After cutting, the cutting table automatically returns to its
start position.
Open the protection guard and release the clamping device.
Remove the workpiece.
Loosen the locking handle on the right hand side of the
machine, so that the cutting handle moves freely.
Clamp the workpiece.
Position the cutting table under the cut-off wheel.
If AUTO mode is selected, de-select it.
s
Press START .
Lower the cut-off wheel until it contacts the workpiece and
apply pressure until the sample is cut.
Keep the Load Bar in the green, or first part of the yellow area.
Relax pressure near the end of the cut.
Open the protection guard and release the clamping device.
Remove the workpiece.
keys.
to begin cutting.
v
and
33