Light Diode And Beep Signals - struers Discotom-6 Gebrauchsanweisung

Light Diode and Beep Signals

Status
Green POWER indicator on
White AUTO indicator on
 Beep signal
2 long  Beep signals
3 long  Beep signals

Red indicator on

indicator on and 
Red
beep signal
Yellow FEED SPEED
REDUCED indicator blinking

Red and yellow FEED
SPEED REDUCED indicators
blinking

Red indicator and 1 red
cell on LOAD BAR

Red indicator and 2 red
cells on LOAD BAR

Red indicator, 2 red cells
on LOAD BAR and  beep
signal
10
Discotom-6
Instruction Manual
Discotom-6 is provided with various light diodes indicating the status
of the machine. Beep signals will sound if a key is pressed when the
function cannot be activated.
Indication
The main power switch has been
turned on.
AUTO mode is active.
You pressed AUTO, START

FORWARDS or BACKWARDS
while the motor was running.

You pressed START
protection guard was open.

You pressed START
while cooling valve isn't in cutting
position.
The emergency stop has been
pressed.
The emergency stop has been
pressed and you tried to press
another key.
In AUTO mode: the feed speed is
too high.
An AUTO cut has finished. Feed
speed reduced.
Cutting in AUTO mode not possible
as the cutting table does not move.
Pump motor overloaded.
Main motor overloaded. Process
halted.
Comments

,

while the
Turn cooling valve to cutting position.
for cutting
Release the emergency stop to shut off

the indicator.
The machine automatically turns the feed
speed down.
Turn the feed speed down or press any
key.
Press any key to stop the indicators.
Material may be too hard for the cut-off
wheel chosen or cutting table may be
jammed. See Trouble Shooting section at
back of manual.
Stop the machine. Push the red button on
the back of the machine to reset the
safety cut-out.
The indicators will disappear when the
motor has cooled down.
You tried to press a key before the motor
had cooled down.