Maintenance of Cutting Tables
Maintenance of Cut-off Wheels
Storing of Bakelite Bonded Al
Cut-off Wheels
Maintenance of Diamond and
CBN Cut-off Wheels
Maintenance of
Clamping Devices
38
Unitom-5
Instruction Manual
The iron rails (available as spare parts) should be replaced if they
have become worn or damaged.
O
These cut-off wheels are sensitive to humidity. Therefore, do not
2
3
mix new, dry cut-off wheels with used humid ones. Store the cut-
off wheels in a dry place, horizontally on a plane support.
The precision of diamond and CBN cut-off wheels (and thus the
cut) depends on how carefully the following instructions are
observed:
Never expose the cut-off wheel to overload, such as heavy
mechanical load, or heat.
Store the cut-off wheel in a dry place, horizontally on a plane
support, preferably under light pressure.
A clean and dry cut-off wheel does not corrode. Therefore,
clean and dry the cut-off wheel before storing. If possible, use
ordinary detergents for the cleaning.
Regular dressing of the cut-off wheel is also part of the
general maintenance.
It is recommended to thoroughly clean and lubricate the
Quick Clamping Device and Vertical Clamping Device at regular intervals.
Important